Roof Razor Jr. Snow Rake/Roof Rake Assembly and Use Instructions

A #1 Phillips screwdriver is needed to tighten the set screw on the axle.

All other poles are interchangeable in length, however, one pole has a hole approximately 16 in. from the male end. This pole should always be the 2nd pole because that is where the bungee is hooked to keep the slide tight.

• Avoid use in windy conditions.
• Keep away from electric wires and antennas.
• This tool is designed to be used while standing on the ground.

NOTE: The Roof Razor Jr. is designed for steeper-pitched roofs. If you have a shallow-pitched roof, then you need the original Roof Razor.